(c)1990 Golden Triangle, Inc. (c)1990 Wilson Van Alst All rights reserved. Fm: GEORGE MCLIN To: all Hey all! I am now the proud new owner of a DVI. I would like to know one thing: Why can't I notch my disks and use the other side??!! ...or am I just doing it wrong? When I do it, all I get is an I/O error or a "NO disk in drive" error. George Mclin 73607,1255 =+=+=+=+=+= Fm: Paul Globman To: GEORGE MCLIN You probably didn't punch a second hole for the index sensor. Besides the write protect notch, there is also a round hole near the center of the disk (as opposed to the edge). You must punch a hole on both sides of the disk sleeve so when the floppy is flipped the index hole can be sensed. =+=+=+=+=+= Fm: GEORGE MCLIN To: Paul Globman Paul, Thanks! I undertand the hole you are talking about, but how do I go about putting it there? ..I don't just puch a hole thru the whole disk do I..? George =+=+=+=+=+= Fm: Paul Globman To: GEORGE MCLIN GEORGE - it's easier said than done, but not impossible. DO NOT put a hole thru the entire diskette! Use a round hole punch and only punch thru the black jacket of the floppy disk. You must do this twice (once on each side of the disk), and it must be in the right place. Take an unmodified disk and rotate the magnetic media within the jacket until the index hole appears. Then flip the diskette and use it as a template to mark the location of the hole needed on another disk. Careful not to touch or bend the media surface when making the hole. Paul =+=+=+=+=+= Fm: GEORGE MCLIN To: Paul Globman Paul, Thanks, I'll try that. ..! ...now if'n I kin find that little hole puncher... George =+=+=+=+=+= Fm: Tony Anderson To: GEORGE MCLIN And you've got to be real careful not to scratch the disk surface. There are combination disk notchers and punchers that are frequently advertised in Computer Shopper magazine, and in magazines which cater to users of single-sided disks; Commodore's primarily. =+=+=+=+=+= Fm: GEORGE MCLIN To: Tony Anderson Thanx for the info, I'll check it out! George =+=+=+=+=+= Starting message #: 188543 Starting date: 09-Oct-89 19:11:35 Participants: GEORGE MCLIN 73607,1255 Paul Globman 72227,1661 Tony Anderson 76703,4062