Power-100 A.R.M.S 12131 Old Buckingham Rd. Midlothian, Va. 23113 (804-794-6675) Yes! The Power-100 will also power the Chipmunk, and other devices listed below. Device Approximate Run Time Chipmunk 30 minutes (continous access) TRP-100 Printer 30 minutes (continous printing) M100 10 hours M200 8 hours CCR 81 Tape Recorder 4.5 hours The run time for the Chipmunk will vary depending on the state of charge of the Chipmunk internal battery. Power-100 will add about fifty percent additional run time to the Chipmunk. Power-100 can be recharged by the Chipmunk A.C. adapter. Note: Both the Chipmunk internal battery and Power-100 are powering the Chipmunk when Power-100 is connected. It is best to disconnect the Power-100 when the Chipmunk is turned off so that energy is not wasted recharging the Chipmunk battery. The Power-100 battery is the ideal solution to the short life and high cost of alkaline penlight batteries. It is a recharageable five cell nicad battery strip which attaches to the back of the Model 100 using velcro. Power- 100 weighs just five ounces, is ten inches long and 3/4 inches in diameter. With Power-100 attached, the Model 100 still fits into its original case. Power-100 will power the Model 100 for about 9 to 12 hours of continuous use and is recharged by the Model 100's own A.C. adapter. The Model 100 can still run off of the A.C. adapter while charging the Power-100. Recharge time is 16 hours but over 70% of the charge is achieved in five hours. The Power-100 maintains the portability of the Model 100 and will pay for itself in less than six months of normal use at a cost of only $39.95. The Power-200 is now available for 49.95 with one third more power than the Power-100. To order this or other Workstation 100 components contact: A.R.M.S 12131 Old Buckingham Rd. Midlothian, Va. 23113 (804-794-6675) Or for more information contact: Bob Ripley [75715,1510]